Rakett begynner sett med Kamera
Leveres komplett med alt
ferdig montert inklusiv :
- Rakett. Lengde : 46 cm, Ø : 3,5 cm &
Vekt : 86 g. Material : Støpt ABS Plast.
- Kamera : Ferdig montert med Kodak 110 film.
(Film leveres med så langt lageret rekker.
Film kan også kjøpes i alle Foto-forretninger).
- Fallskjerm. Diameter : 30 cm
- Utskytnings-Stativ.
- Utskytnings-kontroller, som drives av
4 st. AA batterier (følger ikke med).
- Utførlig 150s Håndbok om Raketter
& utskytnings-regler, på engelsk.
Da Motoren inneholder noen gram med krutt
(kan ikke eksplodere, kun brenne),
må settet selges separat fra Motorene.
Ønsker du å kjøpe Motorer sammen med
Rakett settet, blir det sendt med bil-transport,
ikke i posten
(Be om frakt pris, før du betaler).
Alle Rakettene og Motorene er
CE-godkjent, & UN registrert.
(Bruker B6-4, C6-5, C6-7 motor, som krever en
oppskytnings plass på ca.120 m i diameter).
Best.nr. 5001 ( 9 dagers leverings-tid )
kr. 499,-
Leveres komplett med alt
ferdig montert inklusiv :
- Rakett. Lengde : 46 cm, Ø : 3,5 cm &
Vekt : 86 g. Material : Støpt ABS Plast.
- Kamera : Ferdig montert med Kodak 110 film.
(Film leveres med så langt lageret rekker.
Film kan også kjøpes i alle Foto-forretninger).
- Fallskjerm. Diameter : 30 cm
- Utskytnings-Stativ.
- Utskytnings-kontroller, som drives av
4 st. AA batterier (følger ikke med).
- Utførlig 150s Håndbok om Raketter
& utskytnings-regler, på engelsk.
Da Motoren inneholder noen gram med krutt
(kan ikke eksplodere, kun brenne),
må settet selges separat fra Motorene.
Ønsker du å kjøpe Motorer sammen med
Rakett settet, blir det sendt med bil-transport,
ikke i posten
(Be om frakt pris, før du betaler).
Alle Rakettene og Motorene er
CE-godkjent, & UN registrert.
(Bruker B6-4, C6-5, C6-7 motor, som krever en
oppskytnings plass på ca.120 m i diameter).
Best.nr. 5001 ( 9 dagers leverings-tid )
kr. 499,-
Motor (C6-5)
Leveres i pakker på 6 st.,
med tennstifter, plugger & vatt
( Vatt brukes til å beskytte fallskermen mot varme
)
Du trenger en motor for
hver oppskyting. (Blir sendt med Bil, ikke post)
Best.nr. 5003 ( 9 dagers leverings-tid )
kr. 299,- ( for 6 motorer )
Best.nr. 5005
kr. 499,- ( for 12 motorer )
Best.nr. 5007
kr. 799,- ( for 24 motorer )
Leveres i pakker på 6 st.,
med tennstifter, plugger & vatt
( Vatt brukes til å beskytte fallskermen mot varme
)
Du trenger en motor for
hver oppskyting. (Blir sendt med Bil, ikke post)
Best.nr. 5003 ( 9 dagers leverings-tid )
kr. 299,- ( for 6 motorer )
Best.nr. 5005
kr. 499,- ( for 12 motorer )
Best.nr. 5007
kr. 799,- ( for 24 motorer )
Gratis demo-Video kommer her
Bilde av Motor, tennstifter & plugger
Bilde av Utskytnings-kontroller
| . |
o
.
o
.
Motorer selges kun til personer fra 10
Ã¥r,
med godkjenning av en foresatt,
ellers over 11 år.
Ã¥r,
med godkjenning av en foresatt,
ellers over 11 år.
MODEL ROCKET SAFETY CODE
1. MATERIALS. I will use only lightweight, non-metal parts for the nose, body, and fins of my rocket.
2. MOTORS. I will use only certified, commercially-made model rocket motors, and will not tamper with
these motors or use them for any purposes except those recommended by the manufacturer.
3. IGNITION SYSTEM. I will launch my rockets with an electrical launch system and electrical motor igniters.
My launch system will have a safety interlock in series with the launch switch,
and will use a launch switch that returns to the "off" position when released.
4. MISFIRES. If my rocket does not launch when I press the button of my electrical launch system,
I will remove the launcher's safety interlock or disconnect its battery,
and will wait 60 seconds after the last launch attempt before allowing anyone to approach the rocket.
5. LAUNCH SAFETY. I will use a countdown before launch, and will ensure that everyone is paying attention and
is a safe distance of at least 5 m away when I launch rockets with D (C6-5 & C6-7) motors or smaller,
and 10 m when I launch larger rockets.
If I am uncertain about the safety or stability of an untested rocket, I will check the stability before flight and
will fly it only after warning spectators and clearing them away to a safe distance.
6. LAUNCHER. I will launch my rocket from a launch rod, tower, or rail that is pointed to within 30 degrees
of the vertical to ensure that the rocket flies nearly straight up, and I will use a blast deflector to prevent the
motor's exhaust from hitting the ground. To prevent accidental eye injury, I will place launchers
so that the end of the launch rod is above eye level or will cap the end of the rod when it is not in use.
7. SIZE. My model rocket will not weigh more than 1500 grams at liftoff and will not contain more than 125 grams
of propellant or 320 N-sec of total impulse. If my model rocket weighs more than 500 grams at liftoff or
has more than 113 grams of propellant, I will check and comply with
Federal Aviation Administration regulations (FAA) before flying (Luftfarts-tilsynet).
8. FLIGHT SAFETY. I will not launch my rocket at targets, into clouds, or near airplanes,
and will not put any flammable or explosive payload in my rocket.
9. LAUNCH SITE. I will launch my rocket outdoors,
in an open area at least as large as shown for each rocket-motor,
and in safe weather conditions with wind speeds no greater than 30 km per hour.
I will ensure that there is no dry grass close to the launch pad,
and that the launch site does not present risk of grass fires.
1. MATERIALS. I will use only lightweight, non-metal parts for the nose, body, and fins of my rocket.
2. MOTORS. I will use only certified, commercially-made model rocket motors, and will not tamper with
these motors or use them for any purposes except those recommended by the manufacturer.
3. IGNITION SYSTEM. I will launch my rockets with an electrical launch system and electrical motor igniters.
My launch system will have a safety interlock in series with the launch switch,
and will use a launch switch that returns to the "off" position when released.
4. MISFIRES. If my rocket does not launch when I press the button of my electrical launch system,
I will remove the launcher's safety interlock or disconnect its battery,
and will wait 60 seconds after the last launch attempt before allowing anyone to approach the rocket.
5. LAUNCH SAFETY. I will use a countdown before launch, and will ensure that everyone is paying attention and
is a safe distance of at least 5 m away when I launch rockets with D (C6-5 & C6-7) motors or smaller,
and 10 m when I launch larger rockets.
If I am uncertain about the safety or stability of an untested rocket, I will check the stability before flight and
will fly it only after warning spectators and clearing them away to a safe distance.
6. LAUNCHER. I will launch my rocket from a launch rod, tower, or rail that is pointed to within 30 degrees
of the vertical to ensure that the rocket flies nearly straight up, and I will use a blast deflector to prevent the
motor's exhaust from hitting the ground. To prevent accidental eye injury, I will place launchers
so that the end of the launch rod is above eye level or will cap the end of the rod when it is not in use.
7. SIZE. My model rocket will not weigh more than 1500 grams at liftoff and will not contain more than 125 grams
of propellant or 320 N-sec of total impulse. If my model rocket weighs more than 500 grams at liftoff or
has more than 113 grams of propellant, I will check and comply with
Federal Aviation Administration regulations (FAA) before flying (Luftfarts-tilsynet).
8. FLIGHT SAFETY. I will not launch my rocket at targets, into clouds, or near airplanes,
and will not put any flammable or explosive payload in my rocket.
9. LAUNCH SITE. I will launch my rocket outdoors,
in an open area at least as large as shown for each rocket-motor,
and in safe weather conditions with wind speeds no greater than 30 km per hour.
I will ensure that there is no dry grass close to the launch pad,
and that the launch site does not present risk of grass fires.
Hvordan virker en Rakett Motor :
Høyde : 200 m
Rakettene kan brukes om og om igjen,
men du må sett i ny motor ved hver
oppskytning.
men du må sett i ny motor ved hver
oppskytning.
200 m
| . |
Fallskjerm
